DENON PMA-700AE PDF

Circuit that is used in DENON’s high-end integrated amplifiers and has been criti- The PMAAE employs DENON’s Signal Level Divided Construction. A broad-branded circuit technique and a single-stage output circuit on high- current transistors are used in PMAAE. The equalizer, loudness scheme ( both. Denon PMAAESilver Amplifier. Great Integrated Amplifier.

Author: Sagor Malagore
Country: India
Language: English (Spanish)
Genre: Life
Published (Last): 4 March 2014
Pages: 235
PDF File Size: 13.53 Mb
ePub File Size: 17.62 Mb
ISBN: 538-2-64922-747-3
Downloads: 28727
Price: Free* [*Free Regsitration Required]
Uploader: Ferr

Distortion increased at rated output, as would be expected, with the lower-order harmonics increasing in level, and additional, higher-order components appearing above the noise floor.

Denon PMAAE Amplifier With Phono Input | eBay

The overall THD figures are tabulated in the chart, at 0. You can download a pdf of the original magazine pages on which this review was published, which includes all the graphs, test result charts, tabulated results and oscillograms mentioned in the test results, by clicking HERE or on the denn at right.

This denom exceptional performance, by any standard. The Denon was no slouch into 4O loads either, producing watts Of some significance was the CCIF intermodulation test, which showed two sidebands at 18kHz and 21kHz surrounding the 19kHz and 20kHz test signals but only the tiniest re-generated signal at 1kHz, at ā€”dB.

  ALAN SILVESTRI FEATHER THEME PDF

Even the two sidebands were an excellent ā€”95dB. Phase error at 20kHz was renon little on the high side, but nothing to be concerned about.

You can clearly see the power supply limitation at 20Hz however, where the Denon returned watts At 1kHz, the Denon delivered a little more again watts, or David Ella and tested by Steve Holding Magazine: And for the price, excellent hi-fi performance.

Distortion was very low, as you can tell from the spectrograms.

As you can see, what little ringing there was was quickly damped. Channel separation was good, with a best of 79dB at 20Hz, reducing to 72dB at 1kHz and 48dB at 20kHz, however the balance between the left and right channels was very slightly out, with a 1.

What Hi-Fi?

p,a-700ae This is not a large error: The 1kHz wave was nearly perfect, and the 10kHz wave showed a very fast rise-time with very little rounding. Stability into an extremely capacitative load was excellent.

  DERMATOBIA HOMINIS PDF

Damping factor was very good: However, all the low-order harmonics were at or below ā€”80dB 0. This time around the results were near-perfect, with channel balance improving to 0. Square wave performance was excellent, with the Hz square wave showing negligible tilt and almost no curvature across the flats.

Denon PMA700AE Amplifier With Phono Input

Since I was interested to re-check the balance and frequency response tests on a fresh sample, I borrowed a brand-new PMAAE and had Newport Test Labs rerun the balance and frequency response tests on this second sample. With the tone controls engaged, the low-frequency response slopes down from 1kHz to end up 2dB down at 80Hz and a further pma-700aw. With a 4O load, the second harmonic component crept up to ā€”90dB 0.